The Ultimate NES Mod

aka: A fully Emulated Nintendo Entertainment System!

Tutorial written by: Mr. Chips

Back to page 1

Back to Page 2

This Page

Finishing Touches:

You should get everything lined up inside, and fitted with glue. I HIGHLY recommend you be gentle with the A/V plug which can seperate from the motherboard easily. It is best to use some glue to make sure it does not smap off or give you audio distortion.

the inside final product. I have shown where it is best to use glue. I used Automotive GOOP, which is by far one of the best adhesives on the market. If you use this, I advise you let it air out outside under cover becuase the smell can give you headaches. Mario isn't much fun with a headache!

Tape the gd-rom down too, but not too firmly. Dont cover the track, motor or lens with the tape. It's too messy to glue it, and it's unneccesary.

Have the wires attached firmly on the side before closing it up. Make sure no loose wires are hanging out. Get yor NesterDC Self-boot CD, stick it in there (with your backup roms too!) put the lid on, put it on it's back with the front facing up and put in the remaining 5 screws which you saved from before.

Turn it on , see if you did everything properly. I suggest using a surge protector right away.

If it does work for you, have fun!

Now you can relive your old favorites, or experience games you've never even played before! (that is, backups which you purchased of course!!)

The End!